紫外荧光光谱法测定焦炉气中的痕量总硫

采用紫外荧光光谱法测定焦炉气制取液化天然气的原料气中痕量总硫,考察了样品引入速率、进样量、气体流量、燃烧温度、取样方式和进样方式等条件对分析结果的影响。总硫检出限为15μL·m-3,测定结果与气相色谱法和微库仑法的结果相吻合,测定值的相对标准偏差(n=7)小于10%。     

废旧橡胶改性沥青的老化研究现状

废旧橡胶改性沥青可显著延长路面寿命。本文综述了国内外废旧橡胶改性沥青的热氧老化、紫外老化和水老化行为,使用宏观性能和微观结构变化分析了橡胶改性沥青老化特点。橡胶改性沥青在热、氧、紫外、水的作用下发生老化,软化点升高,针入度降低,羰基含量增加。特别是光、氧老化对经过水老化后的橡胶改性沥青老化作用尤为明显,水溶解了部分老化产物促进了沥青的老化。目前对于橡胶改性沥青老化过程中胶粉、沥青的结构性能变化和其环境耦合因素对橡胶改性沥青的老化研究及分析手段还很少,在今后的研究中须引起重视。     

Vacuum Ultraviolet Spectrum of IBr

Rydberg transitions for the interhalogen IBr, are reported in the wavelength region 160-130 nm.     

Isolation and Characterization of Badge Hydrolysis Products

Heating a suspension of Bisphenol A diglycidyl ether (BADGE) in 20 : 80 tetrahydrofuran/water at 70°C and subsequent passage of the resulting solution through C18 columns allowed isolation and purification to > 97% of each of the two hydrolysis products 2-[4-(2,3-dihydroxypropoxy) phenyl]-2-[4-(2,3-epoxypropoxy)phenyl]propane (1HP) and 2,2-bis[4-(2,3-dihydroxypropoxy)phenyl] propane (2HP), which were characterized by UV, IR, ₁H and _I3C NMR spectroscopy and mass spectrometry.     

Spectrophotometric Determination of Piperazine,Piperazine Salts and Diethylcarbamazine Citrate with Chloranilic Acid

Abstract

A rapid and sensitive spectrophotometric method is developed for the quantitative determination of piperazine, piperazine salts and diethylcarbamazine citrate. The method is based on the formation of donor-acceptor complexes between the compound and chloranilic acid. The interaction product has a characteristic absorption maximum at about 345 nm. The system obeys Beer's law in the concentration range of 1–10 ugml^?1 of piperazine hexahydrate, adipate, phosphate, citrate and diethylcarbamazine citrate. The effects of several experimantal variables have been studied and the stoichiometric composition of the complex has been determined. The developed procedure has been found to be simple, rapid and precise and its application to various dosage forms was demonstrated and yields results comparable with the standard method.     

Introduction of C-Sulfonate Groups into Disaccharide Derivatives

To prepare C-sulfonate derivatives of disaccharides two different strategies were followed. Thus 6- and 6′-C-sulfocellobiosides 4 and 10–12 were prepared starting from a suitably protected cellobioside. The 6′-C-sulfoaminocellobioside 18 was prepared by construction of the molecule through a glycosylation reaction. In both cases, the synthetic pathway involves regioselective tosylation, introduction of a sulfur atom by nucleophilic displacement with potassium thioacetate and oxidation with hydrogen peroxide.     

Hexamethylphosphoramide as Analytical Reagent: Simultaneous Determination of Cobalt,Iron and Nickel

Abstract

Hexamethylphosphoramide (HMPA) gives, in aqueous solutions in the presence of SCN^? ions, complexes with many metal ions, which absorb in the visible region of spectrum. The spectra have been studied in function of ligand concentration and pH for Co, Ni and Fe complexes. For the Co complex an equation was found that describes the behaviour of the absorption vs. SCN^? and HMPA concentration. Absorption follows Lambert-Beer law and can be used for analytical determinations. Analysis of solutions containing Ni and Co in various ratios of concentration has been performed and results are discussed. Co, Ni and Fe content of an alloy has been measured by this way.     

Development and Validation Method for Silica Determination by Spectrophotometry in Some Herbs and Pharmaceutical Formulations

ABSTRACT

A spectrophotometric method for determination of silica in herbs and herbal pharmaceutical products has been developed and validated. The method showed excellent accuracy and precision with S.D. 1.67 and RSD 1.72%, 2.75%, respectively. The established linearity range was 0.05–0.5 μg/mL(r² > 0.99974). The recovery of silica from spiked placebo was > 95% over the linear range. The method has been successfully used in the analysis of silica in raw material and herbal pharmaceutical formulations. This validated method proved to be rapid and less costly.     

光谱法锌离子检测系统的研究

采取标准锌显色剂与锌发生显色反应，生成不溶于水的絮状络合物。用光谱仪测它的吸光度，研究其特征谱与吸光度的特点，建立其浓度与特征波长吸光度间的数学模型。本文所采用的显色剂主要与锌、铜、镉、镍四种离子发生络合反应。因此分别探索了四种离子高浓度以及低浓度时显色反应的吸光度，最终通过得到锌离子浓度与吸光度的关系式以及锌离子浓度与四波长下四种离子混合溶液显色后的吸光度的关系式，给出了锌离子的吸光度与总吸光度的关系式。显色反应能否满足分光光度法的要求，主要与显色剂的性质有关，同时显色反应的条件也至关重要。因为在显色反应过程中，主要是锌离子与锌显色剂发生络合反应形成络离子，进而形成絮状络合物。络离子一般比较稳定，但在水溶液中也存在着电离平衡，也就是说当显色条件发生变化时，既有可能形成络离子，也有可能发生络离子的分解，从而影响络合反应的程度。显色条件包括显色剂用量、pH值、反应温度、显色时间、待测溶液的盐度以及浊度等。重点研究待测溶液的盐度对锌离子浓度测量值的影响，并通过实验给出影响规律以及校正模型。